STS AWD V6-3.6L (2007)
* ESC/F55 - Electronic Suspension Control
* Overspeed /Warn.
* TCS - Traction Control System
* TPM - Tire Pressure Monitoring
* Smart Beam /TQ5
* Headlamp Level
* Air Quality /K14
* HV Seat /KB6 - Heated/Vented Seat
* Metric FE Units - Fuel Economy Units
* DRL/Z49 - Daytime Running Lamps
* HID/TT6/TT7/TT8 - High Intensity Discharge Lamps
* Fog Lmps not Us /Can
* SWC/K59 - Steering Wheel Control Switches with Adaptive Cruise Control
* SWC/UE1 - with OnStar(R)
* SWC Htd St WHL - with Heated Steering Wheel
After all options were set, save them using Save Options. If the option setting was successfully, Procedure Complete message will be displayed. The
power mode will toggle from Run to Accessory.
Program VIN
This procedure needs to be performed if IPM is replaced. Under Module Setup > IPM menu, perform the program VIN procedure following the Tech 2
instructions.
BPP Sensor Calibration
This procedure needs to performed whenever IPM or BPP sensor was replaced. Refer to Brake Pedal Position Sensor Calibration in Lighting Systems.
See: Sensors and Switches - Body and Frame/Pedal Positioning Sensor/Service and Repair/Procedures
Important: After setup, perform the following to avoid future misdiagnosis:
1. Turn the ignition OFF for 10 seconds.
2. Connect the scan tool to the data link connector (DLC).
3. Turn the ignition ON, with the engine OFF.
4. Use the scan tool in order to retrieve history DTCs from all modules.
5. Clear all history DTCs.
