STS AWD V6-3.6L (2007)
Front Door Panel: All Technical Service Bulletins
Body - Loose Or Cracked Front Door Trim
TECHNICAL
Bulletin No.: 09-08-110-017
Date: July 10, 2009
Subject: Loose or Cracked Front Door Trim Panel Upper Edge Trim (Replace Edge Molding)
Models:
2006-2009 Cadillac STS
Condition
Some customers may comment that the plastic molding at the top of the front door trim panel near the door window is loose, cracked or that a section is
missing.
Cause
This condition may be caused by interference between the trim panel upper edge molding and the inner area of the window weatherstrip. The molding
can catch on the weatherstrip when the door trim panel is being installed.
Correction
Important
Do not replace the door inner trim panel to correct the condition.
Use the following procedure to replace the door trim panel upper molding. This procedure uses a two-part epoxy in place of staples to fasten the molding
to the inner trim panel.
1. Remove the affected front side door trim panel. Refer to Front Side Door Trim Panel Replacement in SI.
