STS AWD V6-3.6L (2007)
5. Release the sail panel plastic push-in retainer using the J 38778, or equivalent.
6. Pull outward at the top in order to release the other integral clip.
7. Pull the sail panel from the C-pillar.
8. Remove the lower shoulder belt fastener.
9. Disengage the shoulder belt and escutheon from the sail panel.
10. Route the rear outboard shoulder belt from the sail panel.
11. Remove the shoulder belt from the sail panel.
12. Remove the sail panel.
Installation Procedure
1. Position the sail panel to the C-pillar.
2. Route the outboard shoulder belt and escutheon through the sail panel.
Important: Ensure the shoulder belt is free of twists.
3. Straighten the belt, if needed, prior to securing the shoulder belt floorpan fastener.
4. Position the upper sail panel downward next to the end of the rear shelf trim panel.
5. Insert the upper metal integral clip (1) on the trim panel to the slot located in the headliner.
6. Insert the lower metal integral clip (2) to the sheet metal.
7. Position the plastic push-in retainer (3) to the hole in the sheet metal.
8. Press inward at the plastic retainer in order to secure.
Notice: Refer to Fastener Notice.
9. Install the fastener with a magnetic-tipped screwdriver.
Tighten the screw to 2 N.m (18 lb in).
10. Secure the seat belt escutheon to the sail panel.
11. Install the screw cover to the sail panel.
12. Enable the SRI system. Refer to SIR Disabling and Enabling.
Windshield Pillar Garnish Molding Replacement
Windshield Pillar Garnish Molding Replacement
