STS AWD V6-3.6L (2007)
5. Position the vacuum brake booster on the cowl counter clockwise from the final installation position so that the locking flanges on the vacuum
brake booster and on the cowl mounting flange engage.
Important: Ensure that the locking tab and the flanges are in the fully engaged position.
6. Turn the vacuum brake booster clockwise with a ratchet on the J 22805-B (2). DO NOT use a flat bladed tool in the locking tab to install the
vacuum brake booster. When the vacuum brake booster is correctly installed, the locking tab (1) slides up the flange and engages the locking
notch.
7. Remove the J 22805-B (2) from the installed vacuum brake booster.
8. Reposition and connect the vacuum hose and check valve assembly to the booster.
9. Remove the surge tank inlet hose from the surge tank.
10. Install the coolant surge tank.
11. Install the surge tank inlet hose.
12. Install the air inlet grille panel.
13. Install the master cylinder to the vacuum brake booster.
14. If equipped with a cross vehicle brace, install the cross vehicle brace.
15. Install the vacuum brake booster pushrod (3) to the brake pedal.
16. Install the vacuum brake booster push rod retaining clip (4) to the brake pedal.
17. Install the left closeout/insulator panel.
