STS AWD V6-3.6L (2007)
Distance Sensor: Adjustments
Distance Sensing Cruise Control Aiming
Tools Required
BO-047670 Distance Sensing Cruise Control (DSCC) Aiming Tool
DSCC Aiming Set Up Procedure
1. Prior to aiming the DSCC, the following steps must be taken:
*
Align the wheels, if necessary, before aiming the DSCC.
*
Inflate the tires to the proper pressure.
*
The vehicle must have a full tank of gas.
*
If any service has been performed on the vehicle, make sure that all of the components are back in their original place.
*
Remove any snow, ice or mud from the vehicle.
*
Stop all other work on the vehicle.
*
Do not load any cargo in the vehicle.
*
Remove the upper front bumper fascia grille. Refer to Front Bumper Upper Fascia Grille Replacement.
2. The area needed for aiming of the distance sensing cruise control (DSCC) will consist of a vertical wall and a level surface 8 m (26 ft 2 in) in
length (a), 3 m (9 ft 9 in) in width (b), and 2 m (6 ft 6 in) in height (c).
3. Place the vehicle so the DSCC module is approximately 6 m (19 ft 7 in) from the vertical wall (a), rock the vehicle to stabilize the suspension,
and center the steering wheel.