STS AWD V6-3.6L (2007)
12. Install the J 28467-1A cross bracket assembly.
13. Hand tighten the J 28467-1A cross bracket wing nuts.
14. Install the J 28467-7A bolt hook through the J 28467-6A bracket.
15. Install the J 28467-34 lift hook wing nut and washer to the J 28467-7A lift hook.
16. Repeat the previous two steps in order to assemble two lift hooks and brackets.
17. Install one of the lift hook and bracket assemblies (1) to the J 28467-3 strut tower tube (2) above the engine rear lift bracket.
18. Install the lift hook J 28467-7A through the engine rear lift bracket. Ensure the hook does not damage adjacent components.
19. Install the other lift hook and bracket assembly (1) to the J 28467-2A radiator shelf tube (2) above the engine front lift bracket.
20. Install the lift hook J 28467-7A through the engine front lift bracket. Ensure the hook does not damage adjacent components.
21. Hand tighten the lift hook wing nuts J 28467-34 in order to remove all slack from the engine support fixture assembly.
Removal Procedure
1. Remove the J 28467-B.
2. Remove the J 28467-501.
3. Install the wiring harness electrical connector bracket to the rear of the left (Bank 2) cylinder head.
4. Install the fuel injector sight shield.
