STS AWD V6-3.6L (2007)
damaged.
2. Install the catalytic converter seal/heat shield to the catalytic converter.
3. Carefully install the catalytic converter to the exhaust manifold.
4. Install the catalytic converter to exhaust manifold fasteners.
5. Connect the oxygen sensor electrical connector.
Notice: Refer to Fastener Notice.
Important: Inspect the catalytic converter seal. Replace the seal if it is worn or damaged.
6. Connect the muffler pipes to the left and right side catalytic converters.
Tighten the muffler nuts to 22 N.m (16 lb ft).
7. If equipped with AWD, install the front driveshaft.
8. Lower the vehicle.
9. Tighten the catalytic converter nuts.
Tighten the catalytic converter nuts to 50 N.m (37 lb ft).
10. Install the right bank exhaust manifold heat shield.
