STS AWD V6-3.6L (2007)
Remove the left rear retainer nuts from the muffler hangers, if present.
Install the left rear washers and the new retainer fasteners while aligning the muffler to the cut out in the rear fascia exit.
Remove the right retainer nut from the right front muffler hanger, if present.
Install the washer and a new retainer fastener to right front muffler hanger, leaving a 5 mm (0.20 in) gap measured from the flat rod end to the retainer.
Remove the right rear retainer nuts from the muffler hangers, if present.
Install the right rear washers and the new retainer fasteners while aligning the muffler to the cut out in the rear fascia exit.
Lower the vehicle and visually inspect the exhaust tips to ensure proper alignment.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.
