STS AWD V6-3.6L (2007)
1. Install the new O-rings into the suction hose.
2. Install the suction hose.
3. Connect the suction hose to the evaporator core.
4. Install the suction hose quick connect fitting.
5. Position the liquid line into the bracket.
Notice: Refer to Fastener Notice.
6. Install the suction hose retaining screw into the bracket.
Tighten the screw to 1 N.m (9 lb in).
7. Raise the vehicle.
8. Connect the suction hose to the compressor.
9. Install the retaining bolt to the compressor.
Tighten the bolt to 9.8 N.m (87 lb in).
10. Install the engine splash shield.
11. Install the LH wheel and tire assembly.
12. Lower the vehicle.
13. Install the air cleaner assembly.
14. Evacuate and recharge the refrigerant system. Refer to Refrigerant Recovery and Recharging.
15. Using J 39400-A, leak test the fittings of the component.
