STS AWD V6-3.6L (2007)
8. Install J 45859, CJ129 Universal Hub Puller - Snap-on, 7394 Universal Hub Puller - OTC, or equivalent to the wheel bearing/hub.
9. Using J 45859, CJ129 Universal Hub Puller - Snap-on, 7394 Universal Hub Puller - OTC, or equivalent carefully disengage the wheel driveshaft
from the wheel bearing/hub.
10. Remove the wheel bearing/hub.
Installation Procedure
1. Install the wheel bearing/hub.
Notice: Refer to Fastener Notice.
Notice: Avoid tool contact to the outer constant velocity boot seal when removing the wheel bearing mounting bolts. Failure to observe this notice
may result in damage to the CV boot.
2. Install the wheel bearing/hub mounting bolts.
Tighten the wheel bearing/hub mounting bolts to 135 N.m (100 lb ft).
