STS AWD V6-3.6L (2007)
5. Install the windshield garnish molding.
6. Install the center pillar garnish moldings.
7. Install the rear sail panel.
8. Install the rear seat back.
9. Enable the SIR system. Refer to SIR Disabling and Enabling.
10. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required
retention period. Refer to Inflator Module Handling and Scrapping.
Inflatable Restraint Roof Rail Module Replacement - Right
Inflatable Restraint Roof Rail Module Replacement - Right Side
Removal Procedure
Caution: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door
pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the
SIS.
Caution: Refer to Restraint System Service Precautions.
Caution: Refer to SIR Inflator Module Handling and Storage Caution.
1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the windshield garnish molding.
3. Remove the center pillar garnish moldings.
4. Remove the rear sail panel.
5. Remove the rear seat back.
6. Remove the connector position assurance (CPA) from the harness connector to the inflatable restraint roof rail module.
7. Disconnect the harness connector from the roof rail module.
8. Lower the headliner to gain clearance to the roof rail module.
