STS AWD V6-3.6L (2007)
Take special care when handling or storing a live (undeployed) inflator module. An inflator module deployment produces a rapid generation of gas. This
may cause the inflator module, or an object in front of the inflator module, to project through the air in the event of an unlikely deployment.
Dual Stage Inflator Module
Dual stage inflator modules have 2 deployment stages. If stage 1 was used to deploy a dual stage inflator module, stage 2 may still be active. Therefore, a
deployed dual stage inflator module must be treated as an active module. If disposal of a deployed or undeployed dual stage module is required both
deployment loops must be energized to deploy the air bag.
Scrapping Procedure
During the course of a vehicles useful life, certain situations may arise which will require the disposal of a live (undeployed) inflator module. Do not
dispose a live (undeployed) inflator module through normal disposal channels until the inflator module has been deployed. The following information
covers the proper procedures for the disposing of a live (undeployed) inflator module.
Do not deploy the inflator module in the following situations:
*
After replacement of an inflator module under warranty. The inflator module may need to be returned undeployed to the manufacturer.
*
If the vehicle is the subject of a Product Liability report related to the SIR system and is subject to a Preliminary Investigation (GM-1241). Do not
alter the SIR system in any manner.
*
If the vehicle is involved in a campaign affecting the inflator modules. Follow the instructions in the Campaign Service Bulletin for proper SIR
handling procedures.
Deployment Procedures
The inflator module can be deployed inside or outside of the vehicle. The method used depends upon the final disposition of the vehicle. Review the
following procedures in order to determine which will work best in a given situation:
Deployment Outside Vehicle (Steering Wheel Module, I/P Module, Side Impact Module, and Roof Rail Module)
Deploy the inflator module outside of the vehicle when the vehicle will be returned to service. Situations that require deployment outside of the vehicle
include the following:
*
Using the SIR diagnostics, you determine that the inflator module is malfunctioning.
*
The inflator module is cosmetically damaged (scratched or ripped).
*
The inflator module pigtail (if equipped) is damaged.
*
The inflator module connector is damaged.
*
The inflator module connector terminals are damaged.
Deployment and disposal of a malfunctioning inflator module is subject to any required retention period.
Caution: Refer to SIR Inflator Module Disposal Caution.
Tools Required
*
J 38826 SIR Deployment Harness
*
J 39401-B SIR Deployment Fixture
*
J 38826-25 Roof rail module adapter
*
J 38826-50 Side impact module adapter
*
J 38826-75 Steering wheel module adapter (dual stage air bags)
*
J 38826-80 I/P module adapter (dual stage air bags)
1. Turn OFF the ignition.
2. Remove the ignition key.
3. Put on safety glasses.
4. Remove the inflator module. Refer to the following:
