STS AWD V6-3.6L (2007)
56. Twist together 2 connector wire leads (the high circuits from both stages of the steering wheel module) to one sets of deployment wires. Refer to
SIR Connector End Views in order to determine the correct circuits. See: Diagrams/Connector Views
57. Inspect that the 3-wire connection is secure.
58. Bend flat the twisted connection.
59. Secure and insulate the 3-wire connection to deployment harness using electrical tape.
60. Twist together 2 connector wire leads (the low circuits from both stages of the I/P module) to one sets of deployment wires. Refer to SIR
Connector End Views in order to determine the correct circuits. See: Diagrams/Connector Views
61. Inspect that the 3-wire connection is secure.
62. Bend flat the twisted connection.
