STS AWD V6-3.6L (2007)
Notice: Refer to Fastener Notice.
4. Install the SDM mounting fasteners.
Tighten fasteners to 9 N.m (80 lb in).
5. Connect the wiring harness connector to the SDM.
6. Install the console.
7. Install the driver and the passenger seats to the original position.
8. Enable the SIR system. Refer to SIR Disabling and Enabling.
Important: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part
number to be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check
and follow the steps thoroughly to ensure that the SDM is set properly.
9. Program the new SDM into the dash integration module (DIM).
10. Refer to Programming and Relearning See: Testing and Inspection/Programming and Relearning
