STS AWD V6-3.6L (2007)
2. Position the sensor horizontally on the mounting surface.
3. Point the arrow on the sensor toward the front of the vehicle.
Notice: Refer to Fastener Notice.
4. Install the mounting fasteners.
Tighten the fastener to 9 N.m (80 lb in).
5. Connect the harness wiring connector to the front end sensor.
6. Install the CPA to the wiring harness connector on the front end sensor.
7. Reposition the radiator.
8. Install the radiator sight shield.
9. Enable the SIR system. Refer to SIR Disabling and Enabling.
