STS AWD V6-3.6L (2007)
1. Install the brake fluid pressure sensor (2) to the EBCM (1).
Tighten the brake fluid pressure sensor to 17 N.m (13 lb ft).
2. Connect the brake fluid pressure sensor electrical connector (3) to the brake fluid pressure sensor (2).
3. Fill and bleed the hydraulic brake system.
4. Perform the Auto Bleed Procedure.
5. Perform the Diagnostic System Check - Vehicle. Go to Diagnostic System Check - Vehicle. See: Testing and Inspection/Initial Inspection and
Diagnostic Overview/Diagnostic System Check - Vehicle
