STS AWD V6-3.6L (2007)
Notice: Refer to Component Fastener Tightening Notice.
Important: New oxygen sensors should have a special anti-seize compound already applied to the sensor threads. If you are installing the
original sensor, apply anti-seize compound GM P/N 5613695 or equivalent to the sensor threads.
1. Install the HO2S.
Tighten the HO2S to 40 N.m (30 lb ft).
2. Connect the HO2S electrical connector.
3. Install the HO2S wiring harness to the transmission case.
4. Lower the vehicle.
