STS AWD V6-3.6L (2007)
Steering Shaft: Service and Repair
Upper Intermediate Steering Shaft Replacement
Upper Intermediate Steering Shaft Replacement
Removal Procedure
Caution: Refer to Restraint System Service Precautions.
Notice: The front wheels of the vehicle must be maintained in the straight ahead position and the steering column must be in the LOCK position
before disconnecting the steering column or intermediate shaft. Failure to follow these procedures will cause improper alignment of some
components during installation and result in damage to the SIR coil assembly.
1. Disable the SIR system. Refer to SIR Disabling and Enabling.
Important: The steering column is removed with the upper intermediate shaft attached.
2. Remove the steering column.
Important: Note the relationship of the upper intermediate shaft to the steering column in order to ensure proper installation.
3. Remove the upper intermediate shaft to steering column retaining bolt.
4. Remove the upper intermediate shaft from the steering column.
Installation Procedure
1. Install the upper intermediate shaft to the steering column as noted during removal.
Notice: Refer to Fastener Notice.
2. Install the upper intermediate shaft to the steering column retaining bolt.
Tighten the bolt to 48 N.m (35 lb ft).
Important: The steering column is installed with the upper intermediate steering shaft attached.
3. Install the steering column.
4. Enable the SIR system. Refer to SIR Disabling and Enabling.
