STS AWD V6-3.6L (2007)
5. Loosen the front ride sensor retaining nut.
6. Gently tap the front ride sensor retaining stud in order to loosen the stud to fender connection.
7. Remove the front ride sender from the vehicle.
Installation Procedure
1. Position the sensor to the vehicle.
Notice: Refer to Fastener Notice.
2. Install the front ride sensor retaining nut.
Tighten the nut to 9 N.m (80 lb in).
3. Connect the front ride sensor link to the upper control arm ball stud.
4. Connect the front ride sensor harness connector.
