STS AWD V6-3.6L (2007)
5. Install the upper control arm to the steering knuckle.
6. Install the upper control arm to steering knuckle retaining nut.
Tighten the nut to 80 N.m (59 lb ft).
7. Vehicles equipped with ESC, or automatic headlamp aiming, connect the suspension position sensor link rod to the upper control arm.
8. Install the shock yoke.
9. Install the shock to the yoke.
10. Install the tire and wheel.
11. Lower the vehicle.
Shock, Shock Component, and/or Spring Replacement
Shock, Shock Component, and/or Spring Replacement
Removal Procedure
Notice: Use care when handling the coil springs in order to avoid chipping or scratching the coating. Damage to the coating will result in
premature failure of the coil springs.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the shock module from the vehicle.
4. Install the shock module into the spring compressor.
5. Mark the upper control arm assembly and insulator for proper installation.
