STS AWD V6-3.6L (2007)
Notice: Refer to Component Fastener Tightening Notice.
3. Install the sensor nut and position the sensor body parallel to the inside wheel surface while tightening.
Tighten the sensor nut to 7 N.m (62 lb in).
Important: Before reinstalling the tire on the wheel, note the following items to avoid tire pressure sensor damage upon tire mounting.
*
Position the mounting/dismounting head 180 degrees from the valve stem.
*
Position the bead transition area 45 degrees counterclockwise of the valve stem.
*
Using the tire machine, rotate the tire/wheel assembly clockwise when transferring the tire bead to the inside of the wheel rim.
*
Repeat items for the outer bead.
Install the tire on the wheel.
Important: A service replacement tire pressure sensor is shipped in OFF mode. In this mode the sensors unique identification code cannot
be learned into the antenna modules memory. The sensor must be taken out of OFF mode by spinning the tire/wheel assembly above 32
km/h (20 mph) in order to close the sensors internal roll switch for at least 10 seconds.
4. Install the tire/wheel assembly on the vehicle.
5. Lower the vehicle.
6. Learn the tire pressure sensors. Refer to Tire Pressure Sensor Learn.
