STS AWD V6-3.6L (2007)
2. Disconnect the electrical wiring harness connector (1) from the 2-3 shift solenoid (2).
3. Using a small screwdriver or pick, remove the 2-3 shift solenoid retainer from the control valve body.
4. Remove the 2-3 shift solenoid (7) from the control valve body.
5. Remove the O-ring seals (4-5) from the 2-3 shift solenoid (7) ONLY if the O-rings are cut or worn.
Installation Procedure
1. Install new O-ring seals (4-5) to the 2-3 shift solenoid (7), if the O-rings were previously removed.
2. Install the 2-3 shift solenoid (7) into the control valve body.