STS AWD V6-3.6L (2007)
11. Remove the fluid filter (2). Use a long screwdriver in order to pry the fluid filter neck out of the seals.
12. Remove the 2 fluid filter seals (1) using J 23129 and J 6125-1B.
Installation Procedure
1. Install 2 NEW fluid filter seals (1), onto the transmission fluid filter neck. Coat the new seals with a small amount of J 36850 or petroleum jelly
before installation.
2. Install the transmission fluid filter (2) into the case.
Important: Fluid pan gaskets are reusable. Replace the gasket ONLY if the sealing surface is damaged.
3. Install the fluid pan (2) and the gasket (4) at the same time.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the fluid pan bolts (3).
Tighten the bolts to 11 N.m (97 lb in).
5. Fill the transmission to the proper level. Refer to Transmission Fluid Checking.
6. Lower the vehicle.
7. Inspect the oil pan gasket for leaks.
