STS AWD V6-3.6L (2007)
2. Remove and discard the torque converter seal bolts.
3. Remove the torque converter seal using J 45000.
Installation Procedure
1. Assemble J 8092 onto J 44766.
2. Install the torque converter seal onto the tool before installing into the case to prevent damage to the seal.
Important: Align the torque converter seal with the bolt holes.
3. Install the torque converter seal into the torque converter housing.
Notice: Refer to Fastener Notice.
4. Install the torque converter seal bolts.
Tighten the NEW torque converter seal bolts to 3.6 N.m (32 lb in).
5. Install the transmission torque converter.
Extension Housing and Seal Replacement
Extension Housing and Seal Replacement
Removal Procedure
