STS AWD V6-3.6L (2007)
Shift Linkage: Service and Repair
5L40-E/5L50-E - Automatic Transmission
Shift Control Linkage Replacement (AWD)
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the nut from the shift control linkage rod.
3. Disconnect the shift control linkage rod from the shift control assembly.
4. Remove the manual shift shaft nut.
5. Remove the shift control linkage from the vehicle.
Installation Procedure
1. Install the shift control linkage to the vehicle.
Notice: Refer to Fastener Notice.
2. Install the manual shift shaft nut.
Tighten the nut to 9 N.m (80 lb in).