STS AWD V6-3.6L (2007)
1. Install the housing cover O-ring (2) into the groove on the housing cover (3).
2. Apply a light coat of oil to the housing cover O-ring (2) and install the housing cover (3) onto the housing (1).
Notice: Refer to Fastener Notice.
3. Install the 9 side cover bolts (4).
Tighten the 9 side cover bolts in a criss-cross pattern to 25 N.m (18 lb ft).
4. Install the rear differential.
Drive Pinion Flange/Yoke and/or Oil Seal Replacement
Drive Pinion Flange/Yoke and/or Oil Seal Replacement (V6 Engine)
Tools Required
*
J 45005 Seal Installer
*
J 45012 Holding Fixture
*
J 45019 Flange and Pinion Cage Remover
*
J 34826 Hub Nut Socket (36 mm)
Removal Procedure
1. Raise and support vehicle. Refer to Vehicle Lifting.
2. If vehicle is equipped with dual exhaust, remove the exhaust system.