STS AWD V6-3.6L (2007)
Important: Remove only the propeller shaft coupler-to-differential flange bolts. Do NOT remove the coupler from the propeller shaft.
3. Remove the propeller shaft.
4. Install the J 45012 to the flange.
5. While holding the J 45012, remove the drive pinion nut, using J 34826.
6. Remove the J 45012.
7. Install the J 45019 to the flange.
8. Using the J 45019, remove the flange.
9. Using a flat-bladed tool, remove the drive pinion seal. Take care not to damage any sealing surfaces.
Installation Procedure
Important: Ensure the pinion bore is free of excess gear oil. Excessive fluid can get trapped behind the new seal's dust shield. The trapped
gear oil can get squeezed out when installing the pinion flange and give the illusion of a continued leak.
