cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

07-04-20-003A|Page 12210 > < All Technical Service Bulletins for Seals and Gaskets:|07204E|Page 12207
Page 1
background image

Seals and Gaskets: All Technical Service Bulletins
Drivetrain - Front or Rear Axle Pinion Seal Leak

Bulletin No.: 07-04-20-003A

Date: December 17, 2007

TECHNICAL

Subject:
Front or Rear Axle Pinion Seal Leak (Replace Seal(s))

Models:
2003-2007 Cadillac CTS
2004-2007 Cadillac SRX
2005-2007 Cadillac STS
2006-2007 Pontiac Solstice
2007 Saturn Sky
2007 Daewoo G2X
2007 Opel GT

Supercede:

This bulletin is being revised to update the VIN breakpoints called out in the Parts Information section. Please discard Corporate Bulletin Number
07-04-20-003 (Section 04 - Driveline/Axle).

Condition

Some customers may comment that the rear axle seal is leaking fluid. This condition also applies to the front axle seal on vehicles equipped with
All-Wheel Drive.

Confirm the condition following the Rear/Front Axle Lubricant Leak Diagnosis in SI. 

Correction 

A new pinion seal is now available from GMSPO for service on the vehicles referenced above. It is similar in design to the new pinion seal used in
production beginning with vehicles produced for the 2008 model year. It is not interchangeable due to some slight dimensional differences.

Replace the pinion seal with the new design seal, which is included in the pinion seal kits listed below with their applications. The kits include a new
pinion yoke and pinion nut, which should be used when replacing the seal, using the procedures in SI.

When replacing the pinion seal, make sure that the pinion bore is free of excess fluid that could get trapped before the yoke is installed. Install the new
seal and yoke promptly, before excess fluid seeps into the area. It may be necessary to drain some or all of the axle fluid to assure that the pinion bore
remains free of fluid during seal installation. This should prevent the lube from being trapped behind the dust shield.

If a vehicle has had a service axle installed that uses the new 2008 model design, it cannot use the pinion seal kits listed below because of dimensional
differences.

Rear Axle Pinion Cartridge Casting # 6457038590

07-04-20-003A|Page 12210 > < All Technical Service Bulletins for Seals and Gaskets:|07204E|Page 12207