STS AWD V6-3.6L (2007)
- If the axle part number is listed in the table above, the axle has the new design seal. No further action is required.
-
If the axle part number is NOT listed in the table below, proceed to the Pinion Seal Replacement Procedure below
Axle Assembly Identification
The axle part number is on an adhesive label on the top side of the axle. It can be read in the vehicle using a small mirror. Another means of identifying
an axle that has the new design pinion seal is by referring to Technical Service Bulletin (TSB) 07-04-20-003. A service axle that uses the 2008
production pinion seal can be identified by a casting number that is visible on the pinion cartridge casting immediately behind the yoke. The new design
casting number for the rear axle is 6457038590. The new design casting number for the front axle is 6507022390. Refer to TSB 07-04-20-003 for
illustrations and more information. Use the "Inspect - New Axle Previously Installed - No Further Action Required", V1794 labor operation code for
inspection only claims.
Pinion Seal Replacement
Notice:
To avoid pinion seal damage, use the required special tools. Refer to SI for special tool and procedure information.
Important:
DO NOT reuse the flange and nut as instructed in the service procedure in SI. Use the new flange and nut provided in the kit.
1. Remove the pinion seal. Refer to the appropriate pinion replacement procedure in SI.
2. Replace the pinion seal. Refer to the appropriate pinion seal replacement procedure in SI.
Customer Reimbursement - For GM US
All customer requests for reimbursement of previously paid repairs for the recall condition will be handled by the Customer Assistance Center, not by
dealers.
A General Motors Customer Reimbursement Procedure and Claim Form(Not Shown) is included with the customer letter.
