STS AWD V6-3.6L (2007)
10. Remove the seal from the axle shaft.
11. Remove the wheel drive shaft from the vise.
12. Wrap a shop towel around the joint outer race splined shaft.
13. Place the outer race vertically in a bench vise.
14. Use a brass drift and hammer to gently tap on the wheel drive shaft joints inner cage, until it is tilted enough to remove the first ball.
15. Remove the exposed ball.
Use a small screwdriver to aid in removal, if necessary.
16. Position the cage and inner race so they are level.
17. Repeat steps 14-16 in the removal sequence as shown until all of the balls are removed.
18. Position the cage and the inner race 90 degrees to the centerline of the outer race.
