STS AWD V6-3.6L (2007)
Important: The seal must not be dimpled, stretched, or otherwise deformed.
36. Inspect the seal for proper shape.
If the seal is not shaped correctly, equalize the pressure in the seal by lifting the seal edge slightly and shape the seal properly by hand.
37. Inspect the seal for damage.
If the seal has been cut or punctured during assembly, you must discard and replace the seal.
Important: The seal retaining clamp must not be over-tightened or under-tightened.
38. Using the J 42572, crimp the large seal retaining clamp.
Tighten the large seal clamp until the base of the omega ohm shape has a gap of 1 mm (0.039 in).
The clamping hold time must be no less than 2 seconds.
39. Inspect the outer joint for smooth operation. This will also distribute the grease within the joint.
1. Hold the wheel drive shaft vertically, with the outer joint at the bottom.
2. Rotate the wheel drive shaft 4 or 5 times in a circular motion.
3. Install the wheel drive shaft.
