STS AWD V6-3.6L (2007)
Notice: Avoid tool contact to the outer constant velocity boot seal when removing the wheel bearing mounting bolts. Failure to observe this notice
may result in damage to the CV boot.
9. Carefully remove the wheel bearing/hub retaining bolts.
10. Install J 45859,Snap-on - CJ129 Universal Hub Puller, OTC - 7394 Universal Hub Puller, or equivalent to the vehicle.
11. Using J 45859, Snap-on - CJ129 Universal Hub Puller, OTC - 7394 Universal Hub Puller, or equivalent, carefully separate the wheel driveshaft
from the wheel bearing/hub.
12. Remove the wheel bearing/hub from the vehicle.
Installation Procedure
Notice: Avoid tool contact to the outer constant velocity boot seal when removing the wheel bearing mounting bolts. Failure to observe this notice
may result in damage to the CV boot.
1. Install the wheel bearing/hub to the vehicle.