STS AWD V8-4.6L VIN A (2006)
1. Install the antenna to the roof.
2. Route the wiring pigtail to the side in the slot on the antenna shaft and install the antenna expansion sleeve (3) and bolt (2) to the antenna shaft.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolt to 9 N.m (80 lb in).
3. Connect the antenna connectors (1).
4. Wrap the connectors (1) with foam tape.
5. Install the antenna cable connection above the AM/FM antenna module.
6. Install the antenna cable hold down clips.
7. Align the headliner to the roof panel.
8. Install the rear sail panels.
9. Locate the mast to the antenna base.
10. Install the screws securing the mast to the antenna base.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1 N.m (9 lb in).
