STS AWD V8-4.6L VIN A (2006)
11. Disconnect the EBCM electrical connector (1) from the EBCM and position out of the way.
12. Remove the 4 EBCM to brake pressure modulator valve (BPMV) screws (1).
13. Clean the surface of the EBCM/BPMV assembly.
Important: The EBCM cannot be repaired. If faulty, the unit must be replaced.
14. Separate the EBCM (1) from the BPMV (2).
Installation Procedure
1. Clean the seal surface of the BPMV (2).
2. Make sure that the internal pump motor connector (3) is installed into the new EBCM (1) prior to EBCM replacement.
3. Install the EBCM (1) to the BPMV (2).
