STS AWD V8-4.6L VIN A (2006)
4. Hold the rotor firmly in place against the hub/axle flange and install one of the J45101-100 (1), and one lug nut (2) onto the upper-most wheel
stud.
5. Continue to hold the rotor secure and tighten the lug nut firmly by hand.
6. Install the remaining J45101-100 and lug nuts onto the wheel studs and tighten the nuts firmly by hand in a star-pattern.
7. Using the J39544-KIT, or equivalent, tighten the lug nuts in a star-pattern to specification, in order to properly secure the rotor.
8. If the brake rotor has been REFINISHED or REPLACED with a new rotor, proceed to step 14.
9. If the brake rotor meets the following criteria, proceed to step 10.
^
The rotor is within specifications and is being REUSED
^
The rotor has NOT been refinished
^
The rotor does NOT exhibit thickness variation exceeding the maximum allowable level
