STS AWD V8-4.6L VIN A (2006)
Brake Hose/Line: Service and Repair
Brake Hose Replacement - Rear
Brake Hose Replacement - Rear
Caution: Refer to Brake Fluid Irritant Caution in Service Precautions.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Service Precautions.
Removal Procedure
1. Raise and suitably support the vehicle.
Important: The right rear brake hose is replaced as an assembly, with the intermediate brake hose assembly.
2. Remove the left tire and wheel assembly.
3. Clean all dirt and foreign material from the brake hose and the brake pipe fittings.
4. Disconnect the brake hose (3) from the crossover pipe fitting (1).
Important: Install a rubber cap or plug to the exposed brake pipe fitting end in order to prevent brake fluid loss and/or contamination.
5. Lift the retaining clip over the end of the brake hose.
6. Using a flat-bladed tool, remove the brake hose retainer (2) from the brake hose (3).
7. Remove the brake hose (1) from the frame assembly (2).
