STS AWD V8-4.6L VIN A (2006)
4. Caution: Refer to Compressed Valve Spring Caution in Service Precautions.
Swing the arm over the valve spring retainer and tighten the swivel nut of the J 44211 (2) down only enough to allow access for installation of the
valve locks.
5. Using a magnet, position the valve locks to the valve stem retainer groove. Grease can be used to hold the locks in place.
6. Remove the swivel nut and arm of the J 44211 (2).
7. Install the arm and swivel nut of the J 44211 (2) over the stud of any other valves being serviced and repeat removal steps 12-17 and installation
steps 1-7.
8. Relieve the air pressure to the cylinder being serviced.
9. Remove the J 39313 (1) from the spark plug hole.
10. Remove the base plate of the J 44211 (2).
11. Install the spark plug.
12. Repeat removal steps 7-14 and installation steps 1-11 on any other cylinders being serviced.
13. Install the left camshafts.
14. Remove the EN 46326 (1).
15. Install the starter.
