STS AWD V8-4.6L VIN A (2006)
Crankshaft Main Bearing Seal: Service and Repair
Crankshaft Rear Oil Seal Replacement
^
Tools Required
-
J 42841-A Rear Oil Seal Remover
-
J 45930-A Crankshaft Rear Oil Seal Installer
Removal Procedure
1. Remove the flywheel. See: Transmission and Drivetrain/Flex Plate/Service and Repair
2. Using the J 42841-A remove the rear crankshaft oil seal. Refer to Crankshaft Rear Oil Seal Removal.
Installation Procedure
Important: Make sure the drain is clear before installing the new crankshaft rear oil seal. Failure to clear the drain could cause the crankshaft rear
oil seal to leak.
1. Using the J 45930-A install the rear crankshaft oil seal. Refer to Crankshaft Rear Oil Seal Installation.
2. Install the flywheel.