STS AWD V8-4.6L VIN A (2006)
6. Install the alignment pin through the solenoid alignment hole and into the oil control valve alignment hole.
7. With the alignment pin in place, install the CMP actuator solenoid bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the CMP actuator solenoid bolts to 8 N.m (71 lb in).
8. Remove the alignment pin.
9. Install a NEW CMP actuator solenoid plug.
10. Connect the electrical connector to the actuator solenoid.
11. Install the air conditioning, power steering and water pump drive belt tensioner.
12. Install the remote power steering reservoir.
