STS AWD V8-4.6L VIN A (2006)
2. Install the mode actuator screws (2).
NOTE: Refer to Fastener Notice in Cations and Notices.
Tighten the screws to 1 N.m (9 lb in).
3. Connect the electrical connector to the actuator.
4. Install the I/P carrier.
Air Temperature Actuator Replacement - Right
AIR TEMPERATURE ACTUATOR REPLACEMENT - RIGHT
REMOVAL PROCEDURE
1. Remove the air inlet assembly.
2. Remove the right air temperature actuator screws (1).
3. Remove the right air temperature actuator.
4. Disconnect the right air temperature actuator electrical connector.
INSTALLATION PROCEDURE
1. Connect the right air temperature actuator electrical connector.
