STS AWD V8-4.6L VIN A (2006)
Hazard Warning Flasher: Service and Repair
HAZARD AND TURN SIGNAL FLASHER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the driver side I/P closeout/Insulator panel.
2. Remove the flasher module (2) off the I/P carrier.
3. Disconnect the electrical connector (1).
INSTALLATION PROCEDURE
1. Connect the electrical connector (1) to the flasher module (2).
2. Slide the flasher module retaining clip onto the I/P carrier.
3. Install the driver side I/P closeout/Insulator panel.