STS AWD V8-4.6L VIN A (2006)
Manifold Pressure/Vacuum Sensor: Service and Repair
MANIFOLD ABSOLUTE PRESSURE SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Remove the fuel injector sight shield.
3. Disconnect the manifold absolute pressure (MAP) sensor electrical connector.
4. Remove the bolt (1) and bracket (2) from the MAP sensor (3).
5. Remove the MAP sensor (3).
6. Inspect the MAP sensor seal for wear or damage. If a problem is found, replace as necessary.
INSTALLATION PROCEDURE
