STS AWD V8-4.6L VIN A (2006)
1. Lubricate the camshaft sensor O-ring with engine oil.
IMPORTANT: Inspect the camshaft sensor O-ring for wear or damage. If a problem is found, replace the O-ring.
2. Install the right bank exhaust camshaft position sensor (1) and retaining bolt.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the retaining bolt to 10 N.m (89 lb in).
3. Reconnect the camshaft sensor electrical connector (2).
4. Install the fuel injector sight shield.
5. Operate the engine and inspect the camshaft sensor for engine oil leaks.