STS AWD V8-4.6L VIN A (2006)
4. Install the SDM mounting fasteners.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten fasteners to 9 N.m (80 lb in).
5. Connect the wiring harness connector to the SDM.
6. Install the console.
7. Install the driver and the passenger seats to the original position.
8. Enable the SIR system. Refer to SIR Disabling and Enabling.
9. Program the new SDM into the dash integration module (DIM).
IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to
be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps
thoroughly to ensure that the SDM is set properly. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures
10. Refer to Control Module References for programming and setup information. See: Testing and Inspection/Programming and Relearning
