STS AWD V8-4.6L VIN A (2006)
Traction Control Switch: Service and Repair
Traction Control Switch Replacement
Removal Procedure
1. Remove the console shift lever bezel.
2. Disconnect the traction control electrical connector.
3. Remove the trim plate.
4. Remove the two traction control mounting screws (1).
5. Remove the traction control switch (2).
Installation Procedure
1. Install the traction control switch (2) to the trim plate.
2. Install the two traction control mounting screws (1).
Tighten the two traction control mounting screws to 2 Nm (18 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
3. Connect the traction control electrical connector.
4. Install the console shift lever bezel.