STS AWD V8-4.6L VIN A (2006)
5. Install the nut (3,6) on the wiper arm.
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: Hold the wiper arm into position while tightening the nut.
Tighten the nut to 35 N.m (26 lb ft).
6. Secure the upper hood assist rods onto the assist rod ball studs (1) located on the hood assembly.
7. Install the wiper arm nut covers.
8. Close the hood assembly.
9. Operate the wipers and wash pattern (2) in order to verify the operation.
10. Verify the driver side wiper does not exceed the wipe area (3).
