STS RWD V8-4.6L (2007)
Sun Visor: Service and Repair
Sunshade Replacement
Removal Procedure
1. Detach the sunshade (1) from the sunshade rod retainer clip.
2. Remove the windshield pillar garnish molding.
3. Remove the fasteners from the outboard bezel (2).
Important: The sunshade bezel is secure to the roof by means of a two piece plastic retainer and metal integral clip.
4. The plastic retainer will fall out of the headliner (3) when the three fasteners are removed from the bezel.
Notice: Use care when removing or installing the headliner. Excessive bending will damage the headliner.
5. Carefully reach inside the headliner until the electrical connector (1) is exposed.
6. Disconnect the electrical connector.
7. Remove the sunshade from the vehicle.
Installation Procedure
1. Position the sunshade to the headliner.
2. Push the electrical connector and the wiring through the hole in the headliner.