STS RWD V8-4.6L (2007)
Sunroof / Moonroof Panel: Adjustments
Sunroof Window Height and Opening Fit Adjustment
Adjustment Procedure
1. Cycle the sunroof window from the full open to the full closed position.
Important: Correct adjustment cannot be achieved if the sunroof window is closed from the vent position.
Fully cycle and close the sunroof window.
2. Disconnect the top side of the sunroof panel side opening closeout panel covers (5) from the 3 clips located on the inner edge of the sunroof
window (1, 3, 4) in order to access the window adjustment screws (2, 6).
3. Tape the side opening closeout panels in a downward position prior to adjusting the window.
4. Loosen the 2 adjusting screws (1) on each side of the sunroof window.
5. Center the window front to rear in the opening.
Notice: Refer to Fastener Notice.
6. Adjust the front of the sunroof window (2) from flush to 1 mm (0.04 in) (1) below the top surface of the roof panel (3).
Tighten the adjustment screws to 5.8 N.m (51 lb in).
7. Adjust the rear of the sunroof window (2) from flush to 1 mm (0.04 in) above the top surface of the roof panel (1).
