STS RWD V8-4.6L (2007)
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the brake caliper bleeder valve (1).
Tighten the brake caliper bleeder valve to 14 N.m (124 lb in).
2. Install the brake caliper bleeder valve cap.
3. Lubricate the new piston seal (3) with Delco Supreme 11(R), GM P/N 12377967 (Canadian P/N 992667) or equivalent DOT-3 brake fluid from a
clean, sealed brake fluid container.
4. Install the new lubricated piston seal (3) into the caliper bore seal groove.
5. Make sure the seal is not twisted.
6. Lubricate the brake caliper bore and the piston (1) with brake fluid.
7. Install the caliper piston (1) into the caliper bore.
8. Install the new piston dust boot seal (2) over the piston.
9. Assemble the J 8092 and the J 45507.
1. Using J 8092 and J 45507 fully seat the dust boot seal (2) into the caliper.
2. Make sure the caliper piston dust boot (2) is properly seated into the groove in the brake caliper bore.
10. Install the caliper to the vehicle.
Front Brake Caliper Bracket Replacement
Front Brake Caliper Bracket Replacement
Caution: Refer to Brake Dust Caution.
Removal Procedure
Caution: Do not move the vehicle until a firm brake pedal is obtained. Failure to obtain a firm pedal before moving vehicle may result in
personal injury.
