STS RWD V8-4.6L (2007)
Important: Install NEW copper brake hose gaskets.
3. Assemble the brake hose (2), the NEW copper brake hose gaskets (3), and the brake hose bolt (4) to the brake hose (2).
4. Install the brake hose (2) to caliper bolt (4) to the brake caliper (1).
Tighten the brake hose to caliper bolt to 50 N.m (37 lb ft).
5. Install the brake hose (1) to the brake hose bracket (2).
Important: The tapered end of the hose retainer must be installed toward the pipe.
6. Install the brake hose retainer (3) to the brake hose (3).
7. Remove the rubber cap or plug from the exposed brake pipe fitting end.
8. Install the brake pipe fitting (1) to the brake hose (3).
Tighten the brake pipe fitting to 18 N.m (13 lb ft).
9. Install the wheel speed sensor wiring harness retainers to the brake hose bracket.
10. Bleed the hydraulic brake system.
11. Install the tire and wheel assembly.
12. Lower the vehicle.
